天波超视距雷达路径传播损耗仿真计算与分析

为研究天波超视距雷达路径传播损耗规律特性,针对天波超视距雷达电波传播特点,利用现有理论成果,建立了路径传播损耗的计算机仿真模型,设计了一种简洁的路径传播损耗仿真计算流程,仿真分析了各种因素对路径传播损耗的影响,得出了降低路径传播损耗的有效措施,为天波雷达的作战使用提供了理论依据.     

火炮身管无损检测方法

为了延长火炮身管寿命,进一步提高射击精度。研究火炮身管缺陷检测技术,结合身管不同的损伤类型,通过比较不同的身管检测方法,讨论它们的优缺点和发展前景,并得出相控聚焦超声导波检测新技术的优越性,应用在火炮身管检测中,可占据优势地位,使其可以更好地投入到军队的实际应用中,提高作战效能。     

基于改进Morison公式的海上漂浮软管波浪载荷计算

针对海上漂浮软管波浪载荷计算,分析了软管在海上的形态和受力特点,建立了海上漂浮软管力学分析模型,指出直接运用现有Morison方程计算漂浮软管波浪载荷存在的不足,并根据基本原理提出了改进Morison方程。对海上软质管线处于一定海况,分别运用改进Morison方程与现有Morison方程计算海上波浪载荷,并运用ANSYS软件建立软管模型,结果表明现有Morison方程不适用于计算海上漂浮软管波浪载荷,载荷计算结果偏高约15%,从而验证了改进Morison方程的精确性,有利于准确分析波浪载荷对海上漂浮软管的作用情况。     

Cell-type continuous electromagnetic radiation system generating millimeter waves for active denial system applications

The cell-type continuous electromagnetic radiation system is a demonstration device capable of generating high-power millimeter electromagnetic waves of a specific wavelength and observing their effects on living organisms. It irradiates a biological sample placed in a 30 × 30 × 50 cm³ cell with electromagnetic waves in the 3.15-mm-wavelength region (with an output of ≥1 W) and analyzes the temperature change of the sample. A vacuum electronic device-based coupled-cavity backward-wave oscillator converts the electron energy of the electron beam into radiofrequency (RF) energy and radiates it to the target through an antenna, increasing the temperature through the absorption of RF energy in the skin. The system causes pain and ultimately reduces combat power. A cell-type continuous electromagnetic radiation system consisting of four parts—an electromagnetic-wave generator, a high-voltage power supply, a test cell, and a system controller—generates an RF signal of ≥1 W in a continuous waveform at a 95-GHz center frequency, as well as a chemical solution with a dielectric constant similar to that of the skin of a living organism. An increase of 5 °C lasting approximately 10 s was confirmed through an experiment.     

Monitoring and Prediction of the Vibration Intensity of Seismic Waves Induced in Underwater Rock by Underwater Drilling and Blasting

All underwater drilling and blasting operations generate seismic waves.However,due to a lack of suitable vibration sensing instruments,most studies on the propagation of seismic waves have been limited to shorelines near construction areas or wharfs,whereas comparatively few studies have been conducted on the larger seafloor itself.To address this gap,a seafloor vibration sensor system was developed and applied in this study that consists of an autonomous acquisition storage terminal,soft-ware platform,and hole-plugging device that was designed to record the blasting vibration intensities received through submarine rocks at a given measurement point.Additionally,dimensional analyses were used to derive a predictive equation for the strength of blast vibrations that considered the in-fluence of the water depth.By combining reliable vibration data obtained using the sensor system in submarine rock and the developed predictive equation,it was determined that the water depth was an important factor influencing the measured vibration strength.The results using the newly derived equation were compared to those determined using the Sadowski equation,which is commonly used on land,and it was found that predictions using the derived equation were closer to the experimental values with an average error of less than 10％,representing a significant improvement.Based on these results,the developed sensor system and preliminary theoretical basis was deemed suitable for studying the propagation behavior of submarine seismic waves generated by underwater drilling and blasting operations.     

基于模态分析方法的管道导波频散曲线计算

推导了管道中导波传播的有限元方程,使用 ANSYS 有限元软件建立了管道模型;对导波进行模态分析,得到了管道模型的一系列特征频率与振型,通过对管道振型的模态识别,提取了管道中各模态导波的模态特征,计算得到了管道中导波的频散曲线,该曲线与解析法所得到的频散曲线相吻合。该方法可以应用于周期性重复组合的任何结构（如横截面固定的杆、板、管）中导波的频散曲线计算。     

基于数值模拟的弹药地面库整库燃爆冲击波毁伤风险评估

弹药燃爆事故是我军后方仓库安全管理工作防护的重点,对弹药燃爆事故危害度进行评估,是武器装备安全风险评估体系的重要组成部分.选取地面库整库弹药燃爆事故为研究对象,应用AUTODYN计算程序,建立了弹药地面库的三维空间有限元仿真模型,并对弹药地面库整库爆炸的冲击波传播过程进行了数值模拟,得到了在冲击波不同毁伤等级下人员、建筑物的毁伤区域,为燃爆事故危害度风险评估提供了数据支持.     

GTEM室内脉冲场分析及对数周期天线的响应规律研究

为研究对数周期天线(LPGA)的方波脉冲响应特性,利用GTEM室和CST仿真软件对LPGA方波脉冲响应信号进行实验测试与仿真分析.利用实验室自行研制的超宽带电场测试系统对GTEM室进行校准,得到了室内电场强度E(t)与方波源的输出电压V(t)和芯板高度h之间的关系;搭建GTEM室中天线脉冲响应测试平台,得到不同辐照方向下的LPGA方波脉冲时域响应信号;利用CST仿真软件建立对数周期天线的3D模型,得到响应信号幅值的开路电路模型.     

T型分支坑道对油气爆炸传播特性的影响

为研究T型分支坑道对油气爆炸传播特性的影响,通过对比实验,测定了相同初始条件下T型分支坑道和直坑道中油气混合物爆炸的火焰传播速度和爆炸波超压值。利用高速摄影仪,记录了火焰传播至T型分支坑道时的火焰阵面变化情况,并对T型分支坑道中油气混合物爆炸的传播情况进行了理论分析。结果表明：T型分支坑道对油气混合物爆炸的影响可以视为面积突扩和障碍物扰动双重作用的影响;火焰经过支坑道时,火焰阵面发生扭曲并产生皱褶,表面积增大导致火焰传播速度增大;T型分支坑道处,大量反射波和绕射波进入波后反应区,加强了气流湍流强度,并推动已燃气体回传,迅速提高了燃烧反应速度和能量释放率,起到了增大火焰传播速度和爆炸波超压值的作用。     

岸/舰双基地地波超视距雷达抗电离层干扰研究

针对现阶段困扰低纬度地区高频地波雷达发展的电离层干扰问题,分析了电离层的干扰特性,提出双基地体制下利用收发之间的位置相互关系减小高仰角区的电离层干扰的方案;通过对发射天线进行优化设计,增加天线在俯仰维的孔径,减小向上的能量辐射,达到降低电离层干扰的目的.仿真验证了该方法的有效性.